Chemistry, 08.11.2019 05:31 sarahmckee69

What is the colligative property that means a solution typically has a measurably highter boiling point than a pure solvent alone?

a) osmotic pressure
b) boiling point elevation
c) boiling point alleviation
d) vapor-pressure lowering

Answers: 2

Show answers

Answers

Answer from: jhenifelix

B) Boiling point Elevation states a solution typically has a measurably higher than a pure solvent . So would be B.

Answer from: hrijaymadathil

The colligative property that means that a solution typically has a measurably lower freezing point than a pure solvent alone is the freezing point dep

Answer from: haileyjones732

Option (B) is the correct answer.

Explanation:

When we add a non-volatile solute in a solvent then due to the impurity added to the solution there will occur an increase in the boiling point of the solution.

This increase in boiling point will be known as elevation in boiling point.

This increase in boiling point arises because particles of the non-volatile solute are aligned at the surface of solution due to which solvent particles are not able to escape out of the solution.

Hence, high amount of heat is required for the solute particles to escape out of the solution. Therefore, an increase in boiling point will occur.

Thus, we can conclude that boiling point elevation is the colligative property that means a solution typically has a measurably higher boiling point than a pure solvent alone.

Answer from: jimennacastillo15

B. boiling point elevation

This states that a solution will usually will be measurably higher than a pure solvent.

| If you like this answer, don't be afraid to mark it as Brainliest! |

~Hope this helps babes!

Answer from: christinasmith9633

Boiling point elevation states a solution has a measurably higher than a pure solvent.

Answer from: chaundreascott743

Should be B. good luck

Another question on Chemistry

Chemistry, 21.06.2019 22:00

Bose-einstein condensation occurs at what temperature?

Answers: 2

Answer

Chemistry, 22.06.2019 06:00

This flow chart shows the amount of energy that is emitted by each type of light. ultraviolet > blue light > yellow light > red light (maximum energy) (minimum energy) in an experiment, shining which type of light on a strip of metal would be least likely to produce the photoelectric effect? ultraviolet light dim blue light bright red light bright yellow light

Answers: 2

Answer

Chemistry, 22.06.2019 07:00

All molecules that have some temperature are in what

Answers: 3

Answer

Chemistry, 22.06.2019 14:30

The following data was collected when a reaction was performed experimentally in the laboratory. reaction data reactants products fe2o3 al al2o3 festarting amount in reaction: 3 moles 5 moles ? ? determine the maximum amount of fe that was produced during the experiment. explain how you determined this amount.

Answers: 1

Answer

You know the right answer?

What is the colligative property that means a solution typically has a measurably highter boiling po...

Questions