subject
Engineering, 09.04.2021 01:00 xojade

A three-point bending test was performed on an aluminum oxide specimen having a circular cross section of radius 5.9 mm; the specimen fractured at a load of 4470 N when the distance between support points was 40 mm. Another test is to be performed on a specimen of this same material, but one that has a square cross section of 13 mm in length on each edge. At what load would you expect this specimen to fracture if the support point separation is maintained at 40 mm? Ff = Enter your answer in accordance to the question statement N

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
You know the right answer?
A three-point bending test was performed on an aluminum oxide specimen having a circular cross secti...
Questions
question
Mathematics, 12.10.2019 17:30
Questions on the website: 11526168